Meaning
Flexible support structures experience internal stress that does not return to its original state immediately after a load is removed. In high precision motion systems, flexure strain hysteresis causes a small lag or offset in the position of a stage depending on whether it arrived from a positive or negative direction. This behavior results from molecular friction or microscopic dislocations within the material of the flexure.
It defines the repeatable accuracy of nanopositioning equipment used in fiber alignment or mask inspection.
Positioning Repeatability
Software compensation can often hide small amounts of lag if the movement is predictable. If the material response changes over time, the compensation fails and the tool requires recalibration.
Cyclic Fatigue
The readiness of a flexure design for high volume production depends on its behavior over millions of cycles. A prototype might perform well during initial testing, but the accumulation of internal strain can lead to a shift in the zero point or a reduction in the total range of motion. The cost of calling a material choice early is a sudden failure in the field when the component reaches its fatigue limit.
Production yield for a precision instrument is tied to the consistency of these flexures under continuous load. Demonstrating a stable rate of return to the home position over a long audit run is the only way to verify the design. Lag persists.
Motion Limitation
Rigid materials offer less hysteresis but are more prone to brittle fracture. Selecting the right alloy involves a trade off between the allowable lag and the required travel distance.